Hearth and Home Technologies CARODG36I Not be placed between Fireplace opening Ceiling/overhang

E. Clearances and Framing Dimensions CARODG42I, CARODG42IL

Note: For actual appliance dimensions refer to Section 12.

59-5/8 in.

(1.5 m)

1-1/2 in.

(38 mm)

17in.

(432 mm)

Note: If this surface is inside the building’s warm air envelope...

1-1/2 in. (38 mm)

Side clearances can be zero at framing,

up to 6 inches deep

6 in. 6 in.

...then this surface must be an exterior wall system.

1-1/2 in.

(38 mm)

								at	framing,		.
						zero
											in
							deep			6
						be
					inches
	clearances		can
				6
		to
	up
Side
										51-1/2 in.
										(1.3 m)

ControlBox

82-1/4 in.

(2.1 m)

51-1/2 in.

(1.3 m)

63 in.

(1.6 m)

minimum

36 in. minimum

(889 mm)

from appliance front

Control

Box

	.
6	in

Cement Board

	71-3/4 in.
36 in. minimum	(1.82 m)
(889 mm)	minimum
from appliance front	to top of cement
	board

			50-1/2 in.
			(1.28 m)
36 in. min. (914 mm) Framing			minimum
			header height
noncombustible		36 in. min. (914 mm)
finishing material
	6 in. min.	cement board from
		the top of the firebox
		opening	Flashing
Front	Back		Exterior
			82 in.
			(2.08 m)
NOTICE: Vinyl siding must		floor to ceiling
not be placed between the
fireplace opening and the
ceiling/overhang.

50in.

(1.27 m)

11-1/2 in.

(292 mm) minimum

Interior

50 in.

(1.27 m)

minimum

header height

8-1/4 in.

(210 mm)

17 in.

10-5/8 in.(432 mm)

(270 mm)

Control box

MUST be

relocated!

Combustible Object

36 in.

(914 mm)

	NOTICE: Flash the perimeter of the fireplace, corners and
	the fireplace face in a manner consistent with regional
0 in.	practices as required to prevent water penetration around
	the fireplace or manage water that may penetrate the
	fireplace. See Section 3.D. for more information regarding
	wall and enclosure construction.

 Figure 3.2 Appliance Locations and Framing Dimensions - CARODG42I, CARODG42IL

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. Q • 7/11 8