B. Installing Flue Components
After determining which direction the 45O elbow will be used follow flueing instructions accordingly.
•This fireplace comes ready to flue horizontally. Before attaching additional flue pipe, inspect 45O elbow connection to unit starting collar, if required, snap in place.
•To flue off the unit vertically, the elbow cover plate must first be removed from the unit (see Figure 17).
•The elbow can be removed from the unit by aligning the seams of the elbow to the arrows on the surrounding heat shield (see Figure 18).
•Position the elbow in the vertical position. Snap in place with the starting collar.
•Replace the elbow cover plate aligning it with the elbow and secure in place with the 8 screws.
•Place the rope ring around the first section of pipe and slide it up against the cover plate.
NOTE: The rope ring is needed for the heat manage- ment and to prevent cold air infiltration.
ELBOW COVER PLATE |
Figure 17 |
HEAT | ARROWS |
|
SHIELD |
| |
| ELBOW | ELBOW |
| SEAM | |
FRONT VIEW |
|
|
Figure 18 | TOP VIEW | |
1.Attach the First Flue Component to the Starting Collars
To attach the first flue component to the starting collars of the fireplace:
•Slide the first flue section onto the unit and push in until they snap lock in position.
•Rotate this section to the desired position.
•Using the two tabs provided on the elbow cover plate, secure the first section of flueing to the fireplace with two screws.
Refer to Cinch Pipe and Termination Cap installation instructions.
If the installation is for a termination cap attached directly to the fireplace, skip to the sections, Install Firestops and Flue Termination.
Heat & Glo • | 27 |
