R
Santa Fe Pellet Stove
B. Top Vent Adapter Installation
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
Installing the Top Vent Adapter
1.Put a layer of high temperature silicone on the 3 inch (76mm) exhaust outlet. Figure 18.1
2.Slide the top vent adapter onto the rear exhaust outlet and adjust the assembly to a vertical position.
Figure 18.1
3.Drill 4 holes with #26 drill bit (provided) into the back of the appliance using the outer shield as a pattern (make sure the assembly is vertical).
Figure 18.2
4.Install the 4 mounting screws.
5.Drill 2 holes with #26 drill bit through the rear exhaust outlet using the 2 holes already in the short horizontal pipe in the top vent adapter as a guide. Install the 2 screws. Figure 18.1
6.Install the vent pipe into the top vent adapter (be sure to silicone all joints).
7.To clean the top vent adapter open the
Drill holes in back of stove and secure with 4 screws, 2 on each side
Figure 18.2
C.Rear Vent and Rear Vent to Top Vent Adapter Installation
Silicone
Rear Exhaust
Outlet
to 6 in. 
Offset 
Adapter 
to in. 
Top Vent Adapter 
Use hole on each side as
drilling guide
Figure 18.1
Figure 18.3 - Rear Vent Adapter
Figure 18.4 - Rear to Top Vent Adapter - 90o
1.Put a layer of high temperature silicone on the 3 inch (76mm) exhaust outlet. Figure 18.1.
2.Slide the adapter onto the rear exhaust outlet and adjust the assembly to the appropriate position.
3.Install the vent pipe into the adapter (be sure to silicone all joints)
Page 18 | September 1, 2008 |
