Hearth and Home Technologies SANTAFE-B1 7Appliance Set-Up, Outside Air Kit Instructions

Santa Fe Pellet Stove

7Appliance Set-Up

R

A. Outside Air Kit Instructions

Parts Included in Kit: 1 piece of 2 inch x 3 foot flex hose,

2 hose clamps, 1 collar assembly, 1 termination cap assem- bly, 1 trim ring, 12 screws. (Discard collar assembly and air channel, collar assembly already on appliance).

Tools Needed: Phillips head screwdriver; wire cutters; hole saw or jig saw.

1.Measure distance from floor to air vent opening in stove and mark location on wall.

Use saw to cut opening in wall. Cut a 2-1/2 to 3 inch (64-76mm) opening on inside wall and a 3 to 3-1/2 inch

(76-89mm) opening on outside of house.

2.Use hose clamp to secure flex pipe to collar assembly.

3.Slide trim ring over flex pipe and run pipe through wall.

4.Attach hose to outside termination cap with second hose clamp.

5.Secure termination cap to outside surface.

6.Secure trim ring to interior wall.

CAUTION

Never draw outside combustion air from:

•Wall, floor or ceiling cavity

•Enclosed space such as an attic or garage

Termination

Cap Assembly

Hose Clamp

Trim Ring

Flex Hose

Air Intake Channel

Hose Clamp

Collar Assembly

Figure 17.4

September 1, 2008 7001-142D Page 17