Installer Guide
5 Getting Started
A. Typical Fireplace System
| Termination cap | |
| (Sections 8) | |
| Storm Collar | |
| (Section 8) | |
Additional lateral | Chase Top Flashing | |
(Section 9) | ||
support for chimney |
| |
above roof (or enclosed | (4) Roof Radiation Shields | |
in chase) if needed | (Section 8) | |
(Section 8) |
| |
| Chimney penetrates roof | |
| preferably without affecting | |
| roof rafters (Section 8) | |
| Attic Shield Collar | |
Support straps | (Section 8) | |
| ||
on rafter supports | Attic insulation shield must be used | |
chimney (not shown) | ||
here to keep insulation away | ||
(Section 8) | ||
from chimney if attic is insulated | ||
| ||
| (Section 8) | |
Ceiling firestop |
| |
on floor of attic |
| |
(Section 8) | Framing headed off | |
| ||
Chimney system | in ceiling joists (Section 8) | |
(Section 8) |
| |
Combustible |
| |
framing/header |
| |
on top of |
| |
Enclosed space above | ||
standoffs | and around fireplace (Section 6) | |
(spacers) |
| |
(Section 6) | Mantel and surround (Section 12) | |
| ||
| Decorative facing | |
| and trim (Sections 12) |
Hearth extension (Sections 12)
Outside Air | |
(both sides) | Protective metal |
| |
| hearth strip(s) (Section 7) |
Figure 5.1 Typical Fireplace System
Heat & Glo • | 13 |