Heat & Glo LifeStyle BW36 Listings and Code Approvals, Description of the Fireplace System

BW36 SERIES WOODBURNING FIREPLACE

No one builds a better fire

A. LISTINGS AND CODE APPROVALS

The BW36 Series fireplace system has been tested and listed in accordance with the UL127 Standards, and has been listed by Underwriters Laboratories Inc. for installation and operation in the United States as described in these Installation & Operating Instructions.

The BW36 Series fireplaces have been tested and listed for use with the optional components given on page 4. These optional components may be pur- chased separately and installed at a later date. However, installation of an outside air kit will require significant reconstruction, and should be installed at the time of the initial fireplace installation.

Check with your local Building Code agency prior to installing this fireplace to ensure compliance with local Codes, including the need for permits and follow-up inspections. If any assistance is required during installation, please contact your local dealer or the Heat-N-Glo Technical Services Department, 20802 Kensington Blvd., Lakeville, MN 55044.

Heat-N-Glo is a Division of Hearth Technologies Inc.

WARNING!

THIS HEAT-N-GLO FIREPLACE AND ITS COMPONENTS ARE DESIGNED TO BE

INSTALLED AND OPERATED AS A SYSTEM. ANY ALTERATION TO OR

SUBSTITUTION FOR ITEMS IN THIS SYSTEM, UNLESS ALLOWED BY THESE

INSTALLATION INSTRUCTIONS, WILL VOID THE UNDERWRITERS LABORATORIES

LISTING AND MAY VOID THE PRODUCT WARRANTY. IT MAY ALSO CREATE A

HAZARDOUS INSTALLATION.

READ THROUGH THESE INSTRUCTIONS THOROUGHLY BEFORE STARTING YOUR INSTALLATION AND FOLLOW THEM CAREFULLY THROUGHOUT YOUR PROJECT!

B. DESCRIPTION OF THE FIREPLACE SYSTEM

The HEAT-N-GLO fireplace system consists of the following:

1.	Fireplace/Integral Grate	3.	Chimney System
2.	Hearth Extension	4.	Chimney Termination Cap

Optional components include:

1. Glass Doors 3. Heat Circulating Fans

2.Outside Combustion Air System

NOTE: Illustrations throughout these instructions reflect “typical installations” and are for design purposes only. Actual installation may vary slightly due to indi- vidual design preferences. However, min- imum and maximum clearances must be maintained at all times.

The illustrations and diagrams used throughout these installation instructions are not drawn to scale.

Tools and Building Supplies Normally Required:

Tools	Building Supplies
Saw	Hearth Extension Material
Pliers	Wall-finishing Materials
Hammer	Framing Material
Phillips Screwdriver	Fireplace Surround
Tape Measure	Caulking Material
Plumb Line
Level
Electric Drill and Bits
Framing Square

4-00 3 30491D