14 Appliance Setup
A. Remove Glass Assembly
See Section 14.G.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home
RHEOSTAT | TEMPERATURE |
SWITCH | |
| SENSOR |
Figure 14.1 Fan Wiring with Rheostat |
|
VARIABLE |
|
SPEED SWITCH | JUNCTION BOX |
| |
TEMPERATURE |
|
SENSOR SWITCH |
|
BLUE |
|
Figure 14.2 Detail of Fan Wiring with Rheostat | |
E. Lava Rock, Mineral Wool/Ember Placement
Placing the Lava Rock
See Section 14.F for Lava Rock placement instructions.
WARNING! Risk of Explosion! Follow ember placement instructions in manual. DO NOT place embers directly over burner ports. Replace ember material annually. Improperly placed embers interfere with proper burner operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place the ember material:
•Embers CANNOT be placed directly over ports. See Figure 14.4 for the only exception to this guideline. Care should be taken not to cover the lighting trail of ports (from back to front).
•When placing Glowing Embers® onto the burner care should be taken so that the ports are not covered. Place the
•Some of the small port holes should be covered with ember material. See Figure 14.4 for detail.
•Save the remaining ember materials for use during appli- ance servicing. The embers provided should be enough for 3 to 5 applications.
NO EMBERS |
Figure 14.3 Placement of Embers |
PORT HOLES IN CIRCLED
AREA SHOULD BE COVERED
WITH EMBER MATERIAL. NO
OTHER PORT HOLES MAY
COME INTO CONTACT WITH
EMBER MATERIAL.
Figure 14. 4
Heat & Glo • | 33 |
