F. Install the Log Assembly
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the following instructions.
Note: Figure 1 illustrates the recommended gap between the burner and the lava rock retainer.
Carefully remove the logs from the packaging. CAUTION: Logs are fragile!
Log Set Assembly: LOGS-550-E, 750-E, 950-E
Model: SL-550TR-E, 750TR-E, 950TR-E,
SL-550TV-E, SL-750TV-E, SL-950TV-E
3/8 in.
Burner
Lava Rock
retainer
No lava rock may be placed past this edge.
Figure 1
Indentation
1
Slot
Figure 2
Left rear log tab
Indentation
1
Mate slot with tab
Figure 4
Log #1 : Locate the slot on the bottom right side of log 1. Mate the slot with the right rear log tab. Pull the left end of log #1 forward until it touches the left rear log tab.
Left rear log tabRight rear log tab
Shoulder screw
Lava Rock retainer
Grate tine (4)
Figure 3
Log # 2 should touch firebox
2
Figure 5 | Mate notch with grate tine |
|
Log #2 : Mate the left grate tine with the notch located on the left end of log #2. The right end of log #2 should rest on log #1 as shown. Be sure that the top of log # 2 touches the back of the firebox.
34 | Heat & Glo • |
