•ST375 Square Termination Cap
•TCT375 Terra Cotta Cap
Flange
Termination Cap
Collar
2 in. (51 mm)
Minimum Height
Chase Top
Chimney
Pipe
Place waterproof caulk or sealer under each flange of the termination cap and on top of each screw to help prevent leaks.
The last section of pipe must stop between 2 in. (51
mm)above the top of the chase and 4 3/4 in. (121
mm) below the top of the chase.
2 in. (51 mm)
maximum
4 3/4 in. (121 mm)
maximum
Chase
| Place waterproof sealer | |
Remove 2 screws | under each flange of the | |
termination cap and on | ||
from front & back | ||
top of each screw to | ||
to lift the top off | ||
help prevent leaks. | ||
| ||
Termination Cap | The last section of pipe | |
| must stop between 2 in. | |
| (51 mm) above top of | |
Collar | chase and 7 in. (178 mm) | |
below top of chase | ||
2 in. (51 mm) | ||
| ||
Minimum Height |
| |
Chase Top | 2 in. (51 mm) | |
| 7 in. (178 mm) |
Chase
Chimney
Pipe
Termination cap pipe and chimney section must overlap
Termination cap pipe and chimney section must overlap
Figure 9.6 Installing an ST375 Square Termination Cap
•TS345/TS345P Square Termination Cap
Figure 9.8 Installing a TCT375 Terra Cotta Cap
Collar
2 in. (51 mm)
Minimum Height
Chase Top
Place waterproof sealer under each flange of the termination cap and on top of each screw to help prevent leaks.
Termination Cap
The last section of pipe must stop between 2 in. (51 mm) above the top of the chase and 4 3/4 in. (121 mm) below the top of the chase.
2 in. (51 mm)
maximum
4 3/4 in. (121 mm) 
maximum
Chase
Chimney
Pipe
Termination cap pipe and chimney section must overlap
Figure 9.7 Installing a TS345/TS345P Square Termination Cap
4/12 | Heatilator • Constitution EPA Fireplace • | Page 53 |
