Heatiator C40 C. BTU & Efficiency Specifications, F. Electrical Codes, G. Glass Specifications

Models: C40

1 71
Download 71 pages 48.08 Kb
Page 7
Image 7

C. BTU & Efficiency Specifications

F. Electrical Codes

EPA Certified:

3.25 grams per hour

Efficiency:

up to 77.8%

BTU Output

 

with EPA test fuel:

51,400/ hr.

with cord wood:

70,000/hr

Vent Size:

8 inches

Firebox Size:

2.7 cubic feet

Max Wood Length:

24 inches

Fuel:

Cord Wood

Shipping Weight:

650 lbs

NoTICE: This fireplace is tested and approved as a decorative fireplace. It should not be factored as a primary heat source in residential heating calculations.

NOTICE: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/ NFPA 70-latest edition or the Canadian Electric Code

CSA C22.1.

A 110-120 VAC circuit for this product must be protected with ground-fault circuit-interrupter protection, in compliance with the applicable electrical codes, when it is installed in damp locations.

Electrical Codes are used only if the unit is supplied with a fan.

G. Glass Specifications

This fireplace is equiped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass

D.Non-Combustible Materials

Materials which will not ignite and burn, composed of any combination of the following:

-

Steel

-

Iron

-

Brick

-

Tile

-

Concrete

-

Slate

-

Glass

-

Plasters

Materials reported as passing ASTM E 136, Standard

Test Method for Behavior of Metals, in a Vertical Tube Furnace at 750° C

E.Combustible Materials

Materials made of or surfaced with any of the following materials:

-

Wood

-

Compressed paper

-

Plant fibers

-

Plastic

Any material that can ignite and burn; flame proofed or not, plastered or un-plastered

NOTICE: This installation must conform with local codes. In the absence of local codes you must comply with the UL127, (UM) 84-HUD and NFPA211 in the U.S.A. and the ULC 610-M87 and CAN/CSA-B365 Installation Codes in Canada.

Warning! Risk of Fire! Hearth & Home Technologies disclaims any responsibility for, and the warranty and agency listing will be voided by the following actions.

DO NOT:

install or operate damaged fireplace

modify fireplace

install other than as instructed by Hearth & Home Technologies

operate the fireplace without fully assembling all components

overfire

install an unvented gas log set

install any component not approved by Hearth & Home Technologies

install parts or components not Listed or approved

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For assistance or additional information, consult a qualified installer, service agency or your dealer.

4/12

Heatilator • Constitution EPA Fireplace • 480-1091H

Page 7

Page 7
Image 7
Heatiator C40 C. BTU & Efficiency Specifications, F. Electrical Codes, G. Glass Specifications, D.Non-CombustibleMaterials