Read this manual before installing or operating this appliance.
Please retain this owner’s manual for future references.
Congratulations
Congratulations on selecting a Heatilator wood burning fireplace. The Heatilator fireplace you have selected is designed to provide the utmost in safety, reliability, and efficiency.
As the owner of a new fireplace, you'll want to read and carefully follow all of the instructions contained in this Owner's Manual. Pay special attention to all Cautions and Warnings.
This Owner's Manual should be retained for future reference. We suggest that you keep it with your other important documents and product manuals.
Your new Heatilator wood burning fireplace will give you years of durable use and
Homeowner Reference Information
We recommend that you record the following pertinent information about your appliance.
Model Name: ___________________________________________ Date purchased/installed:__________________
Serial Number:__________________________________________ Location on appliance: ____________________
Dealership purchased from: _______________________________ Dealer Phone: __________________________
Notes: _______________________________________________________________________________________
_____________________________________________________________________________________________
Listing Label Information/Location
The model information regarding your specific appliance can be found on the rating plate usually located in the control area of the appliance.
Tested and | Portland | |
Listed by | Oregon USA |
CUS
Report
TESTED TO
UL 127,
A division of Hearth & Home Technologies Inc. 1915 W. Saunders, Mt. Pleasant, IA 52641
www.heatilator.com
Model:
CONSTITUTION
E
PA CERTIFIED F
IREPLACE
Serial No / Numéro De Série
009
LISTED FIREPLACE, SOLID FUEL TYPE, ALSO SUITABLE FOR MANUFACTURED HOME INSTALLATION. (UM) 84 HUD. "For Use with Solid Wood Fuel Only."
Install and use only in accordance with manufacturer's installation, venting and operating instructions. Any area incorporating warm or cold air ducts shall be enclosed in accordance with the manufacturer's installation instructions.
Contact Your Local Building Or Fire Officials Or Authority Having Jurisdiction About Restrictions, Installation Inspection And Permits Required In Your Area.
WARNING - For Manufactured Homes: Do not install in a sleeping room. An outside combustion air inlet must be provided and unrestricted while unit is in use. The structural integrity of the manufactured home floor, ceiling and walls must be maintained. The fireplace needs to be properly grounded to the frame of the manfactured home.
Components required for installation: HTI SLSeries Pipe, Termination Cap, Hearth Extension and required accessory Chimney Air Kit Part CAK4A.
Do not connect this unit to a chimney serving another appliance.
DANGER: Risk of electrical shock. Disconnect power supply before servicing.
Electrical Rating: 115 VAC <3.0 AMPS 60 Hz
Do not use grate or elevate fire. Build wood fire directly on firebrick.
Do not overfire. If heater or chimney connector glows, you are overfiring.
Do not use a fireplace insert or other products not specified for use with this product.
WARNING - THIS FIREPLACE HAS NOT BEEN TESTEDUSAWITH N UNVENTED G S LOG SET OR ANY LOG SET.
TO REDUCE RISK OF FIRE OR INJURY, DO NOT IN TALL AN UNVENTED G LOG SET OR ANY LOG SET INTO FIREPLACE.
Must provide a source of air to prevent air starvation from combustion which could result of high levels of carbon monoxide.
Replace glass only with 5mm ceramic available from your dealer.
Optional Fire Screen Part
Minimum Clearances To Combustible Material
Chimney sections at any level require a 2” (51mm) minimum air space clearance between the framing and chimney section.
WITHIN NCLOSURE AREA |
|
Appliance to backwall | 1" (25mm) |
Appliance to sidewall | 1" (25mm) |
Duct boots to framing | 0" (0mm) |
Top standoffs to header | 0" (0mm") |
EXPOSED SURFACES |
|
Faceplate to sidewall | 16" (406mm) |
Remote outlet air grills to ceiling | 12"(305mm) |
MANTEL |
|
Mantel from base of fireplace | 60" (1524mm) |
Maximum mantel depth | 12" (305mm) |
FLOOR PROTECTION
Combustible flooring 20" (508mm) in front of and 8" (203mm) to either side of the fuel opening must be insulated with
In Canada: The hearth extension must be installed according to the installation instructions.
U.S. ENVIRONMENTAL PROTECTION AGENCY - Certified to comply with July 1990 particulate emission standards.
| 2011 2012 2013 | Jan Feb | Mar Apr May June July Aug Sept Oct. Nov. Dec. | |
Mfg by: |
|
|
|
|
www.heatilator.com | DO NOT REMOVE THIS LABEL | Made in U.S.A | ||
| ||||
Page 2 | Heatilator • Constitution EPA Fireplace • | 4/20/11 |
