Heatiator ECO-ADV-WS22 M. Blower Operating Instructions, N. Clear Space, 2 - Snap Disc Location

M. Blower Operating Instructions

NOTE: If your wood appliance is equipped with an optional blower, you should follow these guidelines:

Burn Rate

Air Control

Handle Up = Open

Handle Down = Closed

Figure 14.1

1.Initial (cold) startup: Raise the Burn Rate Air Control all the way up to the High setting. The blower tends to cool the appliance. Leave the blower off until the burn is well established, i.e., 30 minutes.

2. High Burn Setting: Raise the Burn Rate Air Control all the way up to the High setting. The blower may remain on.

3.Medium or Medium High Burn Setting: Burn Rate Air Control is closed then opened to 1 inch (pull up). The blower may remain on.

4.Medium Low Burn Setting: Burn Rate Air Control is closed then opened to 1/4 inch to 1/2 inch (pull up). Leave the blower off for the first 30 minutes until the burn is well established.

5.Low Burn Setting: Burn Rate Air Control is closed (down position). Leave the blower off for the first 30 min- utes until the burn is well established.

NOTE: For maximum efficiency and lowest emissions, when operating the blower in either the automatic or manual setting for the low and medium low burn settings leave the blower off until the burn is well established, i.e., 30 minutes,

When reloading the appliance, raise the Burn Rate Air Control all the wall to the High setting for 5 to 15 minutes before setting to the desired burn rate.

6.The blower is equipped with a rheostat (speed control). The highest blower speed is obtained by turning the rheostat on, then adjusting back towards “OFF” as far as possible without turning the blower off. For a low blower speed, turn the control knob clockwise as far as possible

Blower

Snap Disc

Figure 14.2 - Snap Disc Location

7.Snap Disc Location

If you find the blower coming on and off at undesirable temperatures, relocate the snap disc to another location in the designated zone on the back of the appliance. Figure 14.2. There is a manual over-ride switch to deactivate the snap disc, if necessary. See page 40 for location of over-ride switch.

N. Clear Space

•Do NOT place combustible objects within 4 ft (1.2 m) of the front of appliance. See Figure 14.3.

Warning! Do NOT place combustible objects in front of the appliance. High temperatures may ignite clothing, furniture or draperies.

•Mantel - avoid placing candles and other heat-sensitive objects on mantel or hearth. Heat may damage these objects.

Maintain 4 ft. (1.22m) clearance to combustible in front of appliance

Figure 14.3

14 Heatilator • ECO-ADV-WS22 • 7057-128C • August 13, 2010