E. Chimney Height / Rise and Run
•This product was designed for and tested on a 6 inch (152mm) chimney, 14 to 16 feet
•The further your stack height or diameter varies from this configuration, the possibility of performance problems exists.
•Chimney height may need to be increased by 2 - 3% per each 1000 feet (304.8m) above sea level.
•It is not recommended to use offsets or elbows at altitudes above 4000 feet (1219.2m) above sea level or when there are other factors that affect flue draft.
F.Factory-Built Chimney
The chimney can be new or existing, and must meet the following minimum requirements.
•Must be a minimum 6 inch (152mm) diameter (ID) high temperature chimney listed to UL 103 HT (2100oF) or ULC S629M.
•Must use components required by the manufacturer for installation.
•Must maintain clearances required by the manufacturer for installation.
•Refer to manufacturers instructions for installation.
NOTICE: In Canada when using a
S629M, STANDARD FOR 650oC FACTORY-BUILT CHIMNEYS.
WARNING! Risk of Fire!
Inspection of Chimney:
•Chimney must be in good condition and meets the minimum standard of NFPA 211.
•
WARNING! Risk of Asphyxiation!
•DO NOT CONNECT THIS APPLIANCE TO A CHIMNEY FLUE SERVICING ANOTHER APPLIANCE OR TO ANY AIR DISTRIBUTION DUCT OR SYSTEM.
This may allow flue gases to enter the house.
Listed Termination Cap |
| |
Roof Brace (if required) |
| |
| Storm Collar | |
| Flashing | |
Trim Collar on | Listed Chimney | |
Inside Wall | Insulated " T " | |
| ||
Chimney | Wall Support | |
Connector | ||
| ||
Floor |
| |
Protector |
|
Figure 34.1 - Factory-Built Exterior Chimney
Listed Termination Cap |
Storm Collar |
Flashing |
Listed Chimney |
Ceiling Support |
Chimney |
Connector |
Floor |
Protector |
| Figure 34.2 - |
34 | Heatilator • |
