D. Glass Cleaning

D. Glass Cleaning

Frequency: As desired

By: Homeowner

Clean glass with a non-abrasive glass cleaner. Abrasive cleaners may scratch and cause glass to crack.

If the deposits on the glass are not very heavy, normal glass cleaners work well. Heavier deposits may be removed by using a damp cloth dipped in wood ashes or by using a commercially available oven cleaner.

After using an oven cleaner, it is advisable to remove any residue with a glass cleaner or soap and water. Oven cleaner left on during the next firing can permanently stain the glass and damage the finish on plated metal surfaces.

A portion of the combustion air entering the firebox is de- flected down over the inside of the door glass.

This air flow “washes” the glass, helping to keep smoke from adhering to its surface.

When operated at a low burn rate, less air will be flowing over the glass and the smoky, relatively cool condition of a low fire will cause the glass to become coated.

Operating the appliance with the Burn Rate Air Control in the High setting for 15-20 minutes should remove the built up coating.

CAUTION! Handle glass assembly with care. Glass is breakable.

Avoid striking, scratching or slamming glass

Avoid abrasive cleaners

Do not clean glass while it is hot

E. Firebrick Inspection

Frequency: After each ash removal

By: Homeowner

Replace the firebrick if they become, cracked, broken, crumbly and/or if there is a 1/4 inch (6.35mm) gap between the bricks.

The firebox is lined with high quality firebrick, which has exceptional insulating properties. There is no need to use a grate; simply build a fire on the firebox floor. Do not operate appliance without firebrick.

1.After the coals have completely cooled, remove all old brick and ash from unit and vacuum firebox.

2.Remove new brick set from box and lay out to diagram shown.

3.Lay bottom bricks in unit.

4.Install rear bricks on the top of the bottom bricks. Slide top of bricks under clip on back of firebox wall and push bottom of brick back.

5.Install side bricks. Slide top of brick under clips on side of firebox and push the bottom of the brick until it is flush with the side of the unit.

Use Part 832-0550 when ordering individual brick. Provide brick dimension or copy this page, mark the desired brick and take it to your authorized dealer.

 

 

1

1

 

 

1

 

 

1

 

 

1

 

 

1

 

1

 

 

 

1

2

 

1

 

 

 

 

1

 

 

 

1

1

 

 

1

1

 

2

1

1

 

 

1

 

 

1

 

 

2

1

 

 

1

 

 

 

 

 

 

2

Figure 18.1

No.

Brick Size

19 x 4-1/2 x 1-1/4

2 9 x 2-1/4 x 1-1/4

Qty

20

4

18

Heatilator • ECO-ADV-WS227057-128C • August 13, 2010

Page 18
Image 18
Heatiator ECO-ADV-WS22 warranty D. Glass Cleaning, E. Firebrick Inspection, Frequency As desired