D. Locating Your Stove & Chimney
Location of the appliance and chimney will affect perfor- mance. As shown in Figure 26.1 the chimney should:
•Install through the warm space enclosed by the build- ing envelope. This helps to produce more draft, espe- cially during lighting and die down of the fire.
•Penetrate the highest part of the roof. This minimizes the affects of wind turbulence and down drafts.
•Consider the appliance location in order to avoid floor and ceiling attic joists and rafters.
•Locate termination cap away from trees, adjacent structures, uneven roof lines and other obstruc- tions.
Your local dealer is the expert in your geographic area and can usually make suggestions or discover solutions that will easily correct any flue problems you may encountered.
| Recommended Location: | |
Recommended Location: | • | Above peak |
• Above peak | • | Inside heated space |
Location NOT recommended:
•Not the highest point of the roof
•Wind loading possible
Windward
Marginal Location:
• Below peak
Recommended:
•Insulated exterior chase in cooler climates
Marginal Location:
• Wind loading possible
Location NOT recommended:
• Too close to tree
• Below adjacent structure
• Lower roof line
• Avoid outside wall
Leeward
Recommended: Outside Air Intake on windward side
NOT recommended: Outside Air Intake on leeward side
Figure 26.1
E. Chimney Termination Requirements
Follow manufacturer’s instructions for clearance, secur- ing flashing and terminating the chimney.
•Must have an approved and Listed cap
•Must not be located where it will become plugged by snow or other material
Notice: Locating the appliance in a basement or in a location of considerable air movement can cause intermittent smoke spillage from appliance. Do not locate appliance near
•Frequently open doors
•Central heat outlets or returns
•Must terminate at least 3 feet (91cm) above the roof and at least 2 feet (61cm) above any portion of the roof within 10 feet (305cm).
•Must be located away from trees or other struc- tures
NOTICE:
•Chimney performance may vary.
•Trees, buildings, roof lines and wind conditions affect performance.
•Chimney height may need adjustment if smoking or overdraft occurs.
26 | Heatilator • |
