C. Blower Installation (Optional) | D. Adjusting the Blower Speed Control |
1.Align holes in mounting flange of blower with bolt holes in appliance. Blower should be positioned at bottom of rear outer skin as shown in Figure 41.1.
2.Insert and tighten bolts supplied with the kit, securing blower onto outer wall of appliance.
3Place the bracket containing the snap disc and magnet under the bottom left rear corner as shown in Figure 41.1.
See pages 14 and 21 for detailed operating instructions for the blower and snap disc.
CAUTION! Risk of Shock!
•Do NOT remove grounding prong from plug.
•Plug directly into properly grounded 3 prong receptacle.
•Route cord away from appliance.
•Do NOT route cord under or in front of appliance.
The blower speed control for this unit is adjusted at the factory, and normally does not require further adjustment.
NOTE: When the speed control is turned clockwise, it will click on to high speed. Continue to turn the speed control clockwise to decrease the speed. At full clock- wise, the blower should blow gently, but should not stop.
Blower
Snap Disc
Snap Disc Bracket with Magnet
MANUAL:
Snap Disc
AUTO: Fan will turn ON/OFF
Automatically by the Snap Disc
Controls the Fan Speed
Figure 41.1
Heatilator • | 41 |
