2226-935
Figure 5. Place Log #3 | Figure 6. Log #3 |
Log #3 (SRV2226-706): Position Log #3 as shown in Figure 5. Refer to Figure 1 and Figure 6 for location of reference points. Mate the slot located on the bottom of Log #3 with the log pin located on the left side of the burner. Move the left end of Log #3 forward until it comes into contact with the grate tine.
PLACE
TOP END OF
LOG ON FLAT SPOT
4
END OF
LOGS
POSITIONED ON
FLAT SPOTS
5
Figure 7. Place Log #4 | Figure 8. Place Log #5 |
Log #4 (SRV2226-703): Position Log #4 as shown in Figure 7. See Figure 1 and Figure 2 for additional details. Place the top end of log #4 on the fl at spot of Log #1. Position the forked end of Log #4 around the far left grate tine. Rotate the forked end of the log to the left until the right fork touches the grate tine.
Log #5 (SRV2226-705):Position Log #5 as shown in Figure 8. Refer to Figures 1,2 and 3 for placement references. Position the two forked ends of Log #5 on the fl at spots of Log #1 and Log #2. The thicker end of the logs rests on the grate bar.
LOG POSITIONED
ON FLAT SPOT
| FORKED END |
| RESTS ON |
6 | FLAT SPOT |
|
Figure 9. Place Log #6 | Figure 10. Log Set Installed |
Log #6 (SRV2226-704): Position Log #6 as shown in Figure 9. See Figures 1, 2 and 3 for additional details. Rest the forked end of Log #6 on the fl at spot of Log #2. Position the back end of the log on the fl at spot of Log #1. Figure 10 shows the log set properly installed.
32 | Heatilator • NDI30, NDI30-SP, NDI35, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-900 Rev. G • 4/11 |
