Installation for Fan Optional | Heatiator NDI35-SPFK, NDI30 specs

E. Installation for Fan (Optional)

On units already installed, removal of decorative front, surround and gas insert is required.

•Detach ﬂexible liner from back of unit if insert is installed.

•Remove the four screws on the cover plate (see Figure 10.6).

•Install and wire the blower per instruction shipped with the blower. Figure 10.5 also shows a wiring diagram.

•Reinstall the cover plate back on the unit. Make sure the fan does not make contact with the back wall to prevent noise from vibration.

FAN	COVER PLATE

Figure 10.6

28	Heatilator • NDI30, NDI30-SP, NDI35, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-900 Rev. G • 4/11

Image 28

Heatiator NDI35-SPFK, NDI30-SPFK owner manual Installation for Fan Optional

Contents

What to do if you smell gas ModelsHOT Surfaces Homeowner Reference Information CongratulationsXxxxxxxx Table of Contents User Guide Limited Lifetime Warranty Limited Lifetime Warranty Warranty Conditions Listing and Code Approvals Operating Instructions User Guide Gas Fireplace SafetyYour Fireplace Fixed Glass Assembly Remote Controls, Wall Controls and Wall SwitchesClear Space Before Lighting Fireplace Lighting Instructions IPI Final inspection byWhat to do if YOU Smell GAS GAS Valve For Your Safety Read Before Lighting Lighting Instructions Lighting Instructions Standing Pilot Issue Solutions Frequently Asked QuestionsAfter Appliance is Lit Maintenance and Service Maintenance Tasks-HomeownerGlass Cleaning Remote Control Maintenance Tasks-Service Technician Gasket Seal and Glass Assembly InspectionVenting Logs Burner Ignition and Operation Standing Pilot Flame Patterns Getting Started Typical Appliance System Tools and Supplies Needed Design and Installation ConsiderationsInspect Appliance and Components Fireplace Size Requirements Minimum Fireplace OpeningTOP View Front View Side View Minimum Fireplace Size NDI35 NDI30 Mantel and Wall Projections Side View TOP View Termination Locations Vent Termination Minimum Clearances Installation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVent Limits Venting Components Placing, Securing and Leveling the Appli- ance ﬁ replace opening Installing Adaptor and Termination Cap MasonryFactory Built Wood Burning Damper Flashing Kit Optional Gas Information Fuel ConversionGas Pressure Gas Connection Wiring Requirements Standing Pilot Ignition System WiringIntelliFire Ignition System Wiring Electrical Information RED Pilot Assembly Thermocouple ThermopileValve WHT Optional Accessories Requirements Blower Plug 120V Existing Outlet Temperature Sensor Switch Installation for Fan Optional Finishing Clearances to Mantels or other Combustibles above Appliance Appliance Setup Log Set Assembly LOGS-NDI30 Models NDI30, NDI30-SP Install the Log AssemblyLOG #5 LOG #6 LOG Log Set Assembly LOGS-NDI35 Models NDI35, NDI35-SP Log Set Installed Grate Tine Slot Air Shutter Settings Air Shutter SettingNDI30 NDI35 Symptom Possible Causes Corrective Action TroubleshootingStanding Pilot Ignition System Troubleshooting Symptom Possible Cause Corrective Action IntelliFire Ignition System Ues to spark, and main Model Dimensions Appliance Dimension DiagramReference Materials Vent Kits Components Direct Vent Flex Liner Kits Contact Information