•Bend four legs at 90° angle as shown in Figure 15.18.
Bend to a 90° angle
S. Install Floor Cover
Install the floor cover as shown in Figure 15.20.
Figure 15.18 Bend Control Heat Shield Legs
•Place over control plate so that all of the control plate is covered and legs are on bottom pan of appliance. See Figure 15.19.
Control Heat Shield in Place
Figure 15.19 Control Heat Shield - Installed
•Make sure all wires are under the top of the control heat shield and that there are no wires pinched between legs and the bottom pan.
Figure 15.20 Installing Floor Cover
Note: The floor cover in the bottom front of the fireplace may be covering the UL labels. It is loose and can be removed/replaced.
64 | Heatilator • Novus NNXT • |
