CHAPTER 2
Setup and Configuration
Setting the DMX Start Channel
Each StudioPix fixture requires a block of consecutive channels on a
To set the Start Channel on an StudioPix Fixture:
1.Access the fixture’s menu system via the dot matrix display on the fixture’s front panel. For a detailed description of the menu system, see Chapter 3: The Menu System on page 15.
UP and DOWN arrows scroll to an option or a value
MENU button unlocks the menu | ENTER button selects an |
and backs through menu levels | option or a menu value |
2.To unlock the menu, press and hold the Menu button until AddR appears on the LED display. Press the Enter button to select.
3.The display will show the start channel currently assigned to the fixture.
4.Use the Up and Down arrow buttons to select a new DMX start channel. The display will flash a new option ready for selection.
StudioPix™ Protocol Mode | DMX Channel Range | Last Valid Start Channel |
Standard Protocol | 70 | 442 |
|
|
|
RGB Reduced Protocol | 12 | 501 |
|
|
|
Pixel Mapping Protocol | 192 | 321 |
|
|
|
Extended Protocol | 253 | 260 |
|
|
|
5.Press the Enter button to store the new DMX Start channel. The display will stop flashing when a new option is entered.
When setting the Start channel on a fixture, remember:
•A fixture’s physical location on the link does not have to coincide with the order of channel range assignments in the link.
•The fixture’s channel range must not overlap any other device’s channel range on the link. When two devices on the same DMX link have overlapping channel ranges, one or both devices will be disabled or behave erratically. The single exception would be if two or more fixtures need to respond to controller commands in exactly the same way. In that case, those fixtures must be the same type and must share the entire channel range.
12 | StudioPix™ Pixelation Luminaire User Manual |
