Ch 1: Hardware
Powering-On the System
Before turning on the system confirm that the main power LED (green), located on the front panel, is illuminated. If so, you may press the Main Power Switch to boot the system. If the LED is not illuminated you will need to manually access the individual power supplies and turn them on in order starting with Power Supply #1, located on the far left. See the figures and directions below to assist you in accessing and turning on the power supplies.
NOTE: Ensure direct power switch is in the “OFF” or normal position.
| HDDs |
| Power Supply Cover |
HDD Bay Door | Remove these 2 screws |
| located on metal tabs |
Figure 1 Accessing the Power Supplies (1)
Power Supplies
Power Supply door folds down
Figure 2 Accessing the Power Supplies (2)
1.Remove the Power Supply cover by opening the HDD bay door using the key, and then unscrewing and removing the 2 screws located at the bottom of the HDD bay on the metal tabs. See Figure 1 Accessing the Power Supplies (1).
2.Open the Power Supply door by pulling it forward, it folds down to open exposing the power supplies.
4 | Hitachi VisionBase 8880R Server |
