English
6. Storage
After operation of the tool has been completed, check that the following has been performed:
(1)Trigger switch is in OFF position,
(2)Power plug has been removed from the receptacle,
(3)
When the tool is not in use, keep it stored in a dry place out of the reach of children.
7. Replacement of Guard (C)
Guard
After extended use of the tool, sometimes the groove of the Guard
(C) becomes wider. It should be replaced in this case.
When replacing with a new one, loosen the four 4mm flat head screws and remove the Guard (C). After replacing, make a groove on it. Refer to “1. Cutting a groove on the guard” on page 13.
4mm Flat Hd. Screw | Guard (C) |
Fig. 45
8. Replacement of Poly-V-Belt
Pulley (A)
The power of the motor is transmitted to the saw blade by a Poly-
When connecting the belt on pulleys, first connect 2 or 3 teeth of
Pulley (B)
Fig. 46
9. Handle (for transportation and carrying)
Handle (For transportation)
For transportation purpose, pull up the handle retracted in the gear case with one hand and hold the base at the left end grip section with the other to carry.
NOTE: Before transporting or carrying, position saw blade against guard and tighten slide securing knob to stop slide motion.
Base
Fig. 47
10. Lubrication
Lubricate the following sliding surfaces once a month to keep the power tool in good operating condition for a long time (see Fig. 1 and Fig. 2). Use of machine oil is recommended.
Oil supply points:
*Rotary portion of hinge *Rotary portion of vise assembly
*Sliding portion of slide pipe (A) and slide pipe (B) *Rotary portion of holder (A)
25
