Basic operations
To project 1
m
5 7 4 2
5_j4
1
_
1 Turn on the main power switch of the projector [ I: ON].
•The Power indicator lights orange.
2 Press the STANDBY / ON button.
•The Power indicator will blink green and then light green.
•The green blinking indicates warmup.
•After the power is turned on, the lamp will be cooled for approximately 1 rain. and the power cannot be turned on even by pressing the STANDBYJON button.
3
4
5
Remove the lens cap.
Use the ZOOM button to adjust the screen size.
Use the FOCUS button to adjust the focus.
( 1) The | display | shown to the right will appear when | the FOCUS button is pressed. | + + + FOCUS+ + + | |
(2) | Use the FOCUS button to adjust the focus until the image is sharp. |
| |||
(3) | The | message | "Focus" will disappear if any other | button is pressed. |
|
• (When there is no input signal, the Focus characters are not displayed when the input signal is outside the sync range.)
6
7
Turn on the power to the connected equipment.
Refer to page 31 concerning the connection of other equipment.
Press either | the INPUT button of the | |
projector or the VIDEO/RGB button of the |
| |
remote control to select the signal to be | RGB 1 | |
| ||
projected on the | screen. |
|
The selected signal input channel will be displayed in the lower right part of the screen.
13
