Hitachi EP-A7000 instruction manual Operation Buttons and Indicators, Remote Controller

Operation Buttons and Indicators /

P.E-OOshows a page with further description.

Operation Buttons and Indicators

Humidity Level P.E-10, 15

Indicates approx. humidity level in the room during operation.

Low Moderate High Orange Orange Green Orange Orange

Operation Mode P.E-11

Shows the operation mode.

Air Purify, Pollen, Strong

Deodorization

Indicator: Green

Humidify, Skin Moisturize

Indicator: Orange

On/Off Button P.E-14

Use this button to start or stop opera- tion and to switch the operation mode.

Air Sensor P.E-14

Level of air contamination detected by the dust sensor and odor sensor is shown by how the indicator is lit. (Indicator: Green)

Features / Name of Each Component / Operation

Airflow Level P.E-12

Indicates airflow rate during operation. (Indicator: Green)

Auto : Airflow rate during auto operation

: Indicates eco operation is active.

When airflow rate is switched using the airflow button on the remote controller, the selected airflow rate is indicated.

: Silent

: Med

: Strong or Max (blinking)

Clean Humidifying

Filter P.E-18

Shows the time to clean the humidifying filter. (Indicator: Red)

Infrared Remote Receiver

Receives remote control signal.

Timer P.E-13

The indicator is lit when 4-hour timer is set. (Indicator: Green)

Buttons and Indicators / Accessories

Remote Controller

Point the remote controller at the infrared receiver on the purifier when you operate.

The remote controllable distance is approx. 6m maximum when pointing the remote controller squarely to the receiver.

On/Off Button P.E-10

Press this button to start or stop operation.

eco Button P.E-17

Press this button to start or stop eco operation.

Max button P.E-13

Press this button to start max operation.

Airflow Button P.E-12

Press this button to switch airflow rate.

Mode Button P.E-11

Press this button to switch operation mode.

Timer Button P.E-13

Press this button to set Off-timer.

Sensor Setting Button P.E-16

Press this button to switch sensor sensitivity.

Note	The remote control may not work in a room where inverter lighting apparatus or electronic quick
	start lighting apparatus is used, or when the infrared receiver is exposed to direct sunlight.

If you operate the remote controller not pointing straight to the front face of the purifier, the sensitivity will be reduced. Operate the controller from the place in front of the purifier whenever possible.

E-3