Hitachi EP-A7000 Inserting Batteries into Remote Controller, Insert batteries and close the cover

Models: EP-A7000

1 28
Download 28 pages 33.29 Kb
Page 9
Image 9
Inserting Batteries into Remote Controller

Inserting Batteries into Remote Controller

Remove the battery compartment cover.

Remove the battery compartment cover. Cover

Insert batteries and close the cover.

Insert batteries and close the cover. Insert the provided two “AAA” R03 batteries

with the correct polarities as instructed. Gently remove the water tank. Since the batteries are provided when shipped from

the factory, their lives may be shorter than brand-new ones because of self-discharge.

Set the water tank into the water tank holder. Batteries are consumable

Manual background When replacing batteries, replace the two batteries simultaneously. Manual background Only use two manganese batteries or two alkali batteries. Do not mix them.

Preparations

Filling Water Tank (for Humidify Mode and Skin Moisturize Modes)

Gently remove the water tank.

Manual background While pressing the upper part of the water tank handle, lift it obliquely upward, and remove the water tank by supporting it in the bottom.

Manual backgroundManual background Handle

Remove the tank cap and fill fresh tap water of normal temperature.

Rubber packing

Check that the tank cap is equipped with a rubber packing.

Do not push in the

 

Loosen

 

pin in the cap center.

 

 

Tighten

 

 

Doing so may cause

 

 

 

 

 

 

water leakage.

Handle

 

 

Pin

 

 

 

for Operation

Manual background Hold the water tray.

 

Do not carry the water tank by holding its

 

handle. Instead, hold the tank with both

CAUTION

hands and carry it while keeping the tank

 

cap side up. When the water tank is wet,

 

wipe off water drops before carrying.

 

 

Manual background Press the center pin of the tank cap, and check that it comes back by spring.

Manual background Tighten the tank cap firmly, wipe off spilt water, and check that there is no water leakage.

Manual background Wipe off water on the water tank handle if any.

Manual background The tank cap is a consumable part. Manual background P.E-28

(If it leaks water due to deteriorated rubber packing, please purchase separately available part for replacement.)

Pull out the water tray, check that the humidifying filter and tray cover are equipped, and then retract the tray.

Manual background The humidifying filter absorbs water supplied from the water tank for humidifying operation.

Humidifying filter

Manual backgroundManual backgroundManual background Water tray Manual backgroundManual backgroundManual backgroundTray cover Manual background

Set the water tank into the water tank holder.

Manual background Be sure to handle the water-filled tank with both hands. Manual background Press in the tank securely until it clicks. Inadequate setting may cause the water tank to fall or result in water leakage.

Water tray

 

When you remove the water tank, water may

 

 

Slowly pull out the water tray while lifting it

CAUTION

drip from the tank cap. Lay a dry cloth before

obliquely upward.

 

removing the water tank.

Manual background Do not set the water tank without having the water tray in place. Otherwise, the water tank may tip over.

Manual background When you pull out the water tray, be careful not to scratch the floor with bottom of the tray.

CAUTION Manual background Do not leave the detached water tank with its cap closed.

Inner pressure of the tank changes according to ambient temperature change and may cause water leakage or injury due to deformation or damage.

Note

Humidifying function works automatically when the water tank and water tray are filled with water.

If you do not need humidification, operate the unit without filling water in the water tank and water tray.

 

E-9

Page 9
Image 9
Hitachi EP-A7000 instruction manual Inserting Batteries into Remote Controller, Insert batteries and close the cover