This router contains a lithium battery for the
Do not remove the battery from the device, disassemble it, or expose it to temperatures of over 100°C (212°F)
Do not throw or immerse lithium batteries into water.
Dispose of exhausted batteries as required by local regulations.
Remove dust on and around the device regularly. Dust buildup can cause fire or electrical shock, and can result in failure of the device.
The power supply of the
Specific Caution Instructions
!Caution: This is a caution notice. Follow the instructions in this notice to avoid damage to the equipment or a disruption in service.
Condensation may form on the surface and inside the device if it is moved from a cold to a warm location. Using the device in this condition may cause fire or electric shock. After moving the device between two locations with a large temperature variation, let the device stand for a few hours before using.
Do not block the device’s ventilation.
Move the device carefully. Before moving the device, unplug the power cable, disconnect all exterior devices, and remove the stabilization clamps. Failure to follow this warning may damage the device or power cable, causing fire or electric shock.
Do not hold the device by the front and back when moving; the cover may come off, causing the device to fall.
Do not subject the device to extreme temperatures.
Do not place the device in direct sunlight or near heat sources that may cause damage.
A yellow label designates that a Class 1 laser is being used. Light emission is minimal and not hazardous, but avoid looking directly into the laser beam.
Approximate weights of the GR2000 models are as follows:
| xi |
Rev. 1.00 |
|
