Hitachi GR2000-B Series quick start Software, Permanently damage the memory card

Hitachi Gigabit Router GR2000-B Series Quick Start Guide

2.Push the lever toward the direction indicated by the arrow as shown in Figure 2-13below.

Lever

Memory Card

Figure 2-13 Removing a Memory Card

3. Pull out the memory card as shown in Figure 2-14below.

Memory Card

Figure 2-14 Memory Card Removed.

!	Caution:	While the access indicator (ACCESS) for a memory card is lit, the memory
		card is being accessed. DO NOT pull out a memory card or turn off the
		power switch while the memory card is being accessed. If so, you could
		permanently damage the memory card.
		Some commands require a long time to finish accessing a memory card
		when they are executed. Make sure that the access to a memory card is
		finished before pulling it out or turning off the power switch.

2.8Software

Software is preinstalled on the memory card when the GR2000-B is shipped. Refer to the GR2000 Applications Guide for procedures for re-installing software onto a memory card.

2-10	GR2K-GA-0008
	Rev. 1.00