<ID/TITLE Setup Procedure>
ŒWith the cursor located at DATA SET, press the D button. The cursor moves to the ID data set position an the first character flashes.
•Using the L, R, U and D buttons, select an input character.
ŽPress the SET UP button, and the selected character will be entered. (The cursor will then move to the next character position.)
• In the same manner, repeat the above steps and to enter an ID code and TITLE.
•On completion of character input, bring the cursor to RET using the L, R, U or D button. Then, press the SET UP button.
The cursor is returned to DATA SET.
‘To quit the SPECIAL SET mode, press the SET UP button.
←:Flashing shifts one character toward the left.
→:Flashing shifts one character toward the right.
DEL: Flashing character is deleted, and the subsequent character string is shifted left.
INS : A space is inserted at the flashing character position, and the subsequent character string is shifted
right.
RET : The cursor is returned to DATA SET.
14. DTL
Menu for setting detail parameters
1) LEVEL DEP: Dependent level setting
Detail amount, and noise, can be reduced in scene dark components.
Setting range is
the video signal level range. Press L button to decrease the value and reduce the range. Set to 0 by
simultaneously pressing the L and R buttons for about 2 seconds.
2) CRISP: Crispness level setting
Reduces noise when DTL setting is in the range of
3) H/V BALANCE: Balance setting for horizontal and vertical detail amount
Setting range is
4)INITIALIZE: Return each item to factory settings by simultaneously pressing the L and R buttons for about 2 seconds.
29
