lonestar.boo : sa200.fm Page 90 Friday, March 6, 1998 10:53 AM

B Using the BIOS Setup Program

The Auto option may provide a different set of parameters for the same hard disk drive at different times. You should, however, always reconfigure the hard disk drive with the parameters you received the first time. If you use a different set of parameters, you may be unable to read any data on the hard disk drive. Be sure to record the original configuration parameters for your hard disk drive for future use.

Note: If the system determines that the hard disk drive is 528MB or larger (unformatted capacity), it automatically “sees” the hard disk drive using LBA mode. If you are using a 528MB or larger hard disk drive from an older system that does not support LBA mode, the system cannot read it properly. You must reconfigure the BIOS Setup program and reformat the hard disk drive.

CD-ROM/ATAPI Device

Press Enter to access the CD-ROM/ATAPI Device submenu. This submenu shows the ATAPI device installed in the peripheral bay and is automatically determined by the computer. The options are:

None

CD-ROM

ATAPI Removable

The default value for this field is: CD-ROM

Boot Sequence

Press Enter to access the Boot Sequence submenu. Using the <+><-> keys, select the order of the drives that you want the system to go through during the boot-up process. The options are:

Removable Device

CD-ROM Drive

Hard Drive

90

 

 

SA200

 

 

 

 

 

 

 

 

 

 

 

 

Page 102
Image 102
Hitachi SA200 manual Lonestar.boo sa200.fm Page 90 Friday, March 6, 1998 1053 AM, CD-ROM/ATAPI Device, Boot Sequence