Hobart Welding Products 350LX manual Symbols And Definitions

2-3. Symbols And Definitions

NOTE

Some symbols are found only on CE products.

		A	Amperes		Panel–Local			Gas Tungsten Arc			Shielded Metal Arc
								Welding (GTAW)			Welding (SMAW)
		V	Volts		Do Not Switch			Arc Force (DIG)			Spot Timer
					While Welding
			Output		Circuit Breaker			Remote			Temperature
			Protective Earth		Alternating Current			High Frequency -			Input
			(Ground)					Start
			Postflow Timer		Preflow Timer			High Frequency -			High Frequency
								Continuous
			Gas (Supply)		Gas Input			Gas Output			Increase/Decrease
											Of Quantity
			On		Off			Percent			Direct Current
			Balance Control		Maximum Cleaning			Maximum			Electrode Positive
								Penetration
			Electrode		Crater Time			Meter			Single-Phase
			Negative
	U0		Rated No Load	U1	Primary Voltage	U2		Conventional Load			Line Connection
			Voltage (Average)					Voltage
		I1		I2	Rated Welding		X		1	1	Single-Phase
			Primary Current					Duty Cycle			Combined AC/DC
					Current
											Power Source
	IP		Degree Of	I1eff	Maximum Effective	I1max		Rated Maximum		Hz	Hertz
			Protection		Supply Current			Supply Current
			Electrode		Work			Thickness Gauge			Spark Gap
		S	Seconds		Final Current			Start Time			Start Amperage
			Peak Time		Spot Sequence			Start/Crater Se-			Start Sequence
								quence
			Crater Sequence		Pulser			Background Amps			Pulse Frequency
4T			4 Step Trigger Op-
			eration Sequence

OM-356 Page 11