6-5. Replacing Gun Cable Liner
Y Turn Off welding power
|
|
| source and wire feeder. |
|
| 1 | Drive Roll |
|
| 2 | Collet Nut |
|
| Lay gun cable out straight. Remove | |
|
| drive roll on gun and loosen collet | |
|
| nut on liner tube assembly. | |
1 |
| 3 | Gun Connector |
|
|
| |
|
| Remove inlet guide from gun con- | |
|
| nector, and remove old liner. | |
|
| 4 | New Liner |
| 1 | Insert split end of new liner into gun | |
| connector and continue feeding lin- | ||
|
| ||
2 | 2 | er through cable assembly until lin- | |
|
| er | is through collet and all of split |
portion is visible.
Cut off split portion of liner. Position liner as close as possible to drive rolls without touching them. Tighten collet nut. Reinstall inlet guide at gun connector and tighten onto lin- er.
Cut liner as close as possible to control (push motor) drive rolls.
See Section
Pistol Grip Gun |
3
3
Split End | 4 |
|
Ref. 151
