4-2. Air-Cooled Feeder Connections
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 | 4 | 5 | ||||
Rear Panel
25
Connect To |
|
Receptacle On Welding |
|
Power Source | Top View |
1
3
Connect To Positive (+) Weld Output Terminal On Welding Power Source
1 Gas Fitting
Route one end of 10 ft (3 m) gas hose to rear of unit, and connect hose to gas solenoid fitting. Connect remaining end of hose to regulator/flowmeter.
2Weld Cable To Welding Power Source
Select and prepare weld cable according to welding power source manual.
3Weld Cable Grommet
4Current Sensing (Reed) Relay
5Weld Cable Terminal In Feeder
Route one end of weld cable through grommet, through reed relay, and connect to weld cable ter- minal in feeder. Connect remaining end of cable to positive (+) weld output terminal on welding power source.
Close and latch door.
Tools Needed:
9/16 in
Ref. 801
