HOT PARTS can cause severe burns.
DDo not touch hot parts bare handed.
DAllow cooling period before working on torch.
DTo handle hot parts, use proper tools and/or wear heavy, insulated welding gloves and clothing to prevent burns.
FALLING UNIT can cause injury.
DUse lifting eye to lift unit only, NOT running gear, gas cylinders, or any other accessories.
DUse equipment of adequate capacity to lift unit.
DIf using lift forks to move unit, be sure forks are long enough to ex- tend beyond opposite side of unit.
MOVING PARTS can cause injury.
DKeep away from moving parts such as fans.
DKeep all doors, panels, covers, and guards closed and securely in place.
DHave only qualified persons remove doors, panels, covers, or guards for maintenance as necessary.
DReinstall doors, panels, covers, or guards when maintenance is finished and before re- connecting input power.
READ INSTRUCTIONS.
DRead Owner’s Manual before using or servic- ing unit.
DUse only genuine Miller/Hobart replacement parts.
FLYING METAL can injure eyes.
DWear safety glasses with side shields or face shield.
MAGNETIC FIELDS can affect pacemakers.
DPacemaker wearers keep away.
DWearers should consult their doctor before go- ing near plasma arc cutting operations.
FIRE OR EXPLOSION hazard.
D Do not locate unit on, over, or near combustible surfaces.
DDo not install unit near flammables.
DDo not overload building wiring − be sure power supply system is properly sized, rated, and protected to handle this unit.
STATIC (ESD) can damage PC boards.
DPut on grounded wrist strap BEFORE handling
boards or parts.
D Use proper
H.F. RADIATION can cause interference.
DHigh frequency (H.F.) can interfere with radio navigation, safety services, computers, and
communications equipment.
DHave only qualified persons familiar with elec- tronic equipment perform this installation.
DThe user is responsible for having a qualified electrician promptly correct any interference problem resulting from the installation.
DIf notified by the FCC about interference, stop using the equipment at once.
DHave the installation regularly checked and maintained.
DKeep
OVERUSE can cause OVERHEATING.
DAllow cooling period; follow rated duty cycle.
DReduce amperage (thickness) or reduce duty cycle before starting to cut again.
EXPLODING HYDROGEN hazard.
DWhen cutting aluminum underwater or with the water touching the underside of the aluminum, free hydrogen gas may collect under the work- piece.
DSee your cutting engineer and water table instructions for help.
ARC CUTTING can cause interference.
DElectromagnetic energy can interfere with sensitive electronic equipment such as computers and
DTo reduce possible interference, keep cables as short as possible, close together, and down low, such as on the floor.
DLocate cutting operation 100 meters from any sensitive electronic equipment.
DBe sure this cutting power source is installed and grounded according to this manual.
DIf interference still occurs, the user must take extra measures such as moving the machine, using shielded cables, using line filters, or shielding the work area.
1-4. California Proposition 65 Warnings
YWelding or cutting equipment produces fumes or gases which contain chemicals known to the State of California to cause birth defects and, in some cases, cancer. (California Health & Safety Code Section 25249.5 et seq.)
YBattery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
For Gasoline Engines:
YEngine exhaust contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
For Diesel Engines:
YDiesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm.
