You may enter a unit number to start displaying the status of that unit, or simply press the down arrow key to scroll through the list of units. The status display is as shown under Control, except that now the arrow keys may be used to continue scrolling between units.
Porch Light | 00:24:19 | |
LAST COMMANDED | ON | ↓ |
You can also check the state and (if any) the remaining time duration of any Unit.
At this point, you may press the ' # ' key to control the unit as specified under Controlling Units or press ' # # ' to configure and HLC or UPB device.
Note: Only HAI manufactured UPB™ devices (collectively referred to as HLC devices) can be configured using an OmniLT controller. Other UPB™ devices may be used, but cannot be configured using the OmniLT controller; they must be configured using a PC running the UPB™ UPStart configuration software.
Configuring HLC Devices
HLC devices can be configured using an Omni console or OmniTouch touchscreen connected to the OmniLT controller. When configuring HLC devices, the following information is programmed into the HLC device:
¾Network ID (UPB Network ID configured in OmniLT controller)
¾Network Name (HAI Lighting)
¾Unit ID (Unit Number of respective unit)
¾Unit Name (which is the name description given to the respective unit in the OmniLT controller)
¾Room Name (using HLC, the name of the first unit in the respective group is used; otherwise the room number is used)
¾Links (every device in each room is programmed with 6 consecutive Links, starting with Link 1; for example, every device in Room 1 is programmed with Links
¾Other configuration information
When configuring HLC devices using an Omni console or OmniTouch touchscreen, each device (unit number) must first be assigned a name in the OmniLT controller. HAI recommends that you first configure your OmniLT controller (naming all of the HLC units) using the HAI PC Access Software, and then download the information to the OmniLT controller.
Configuring HLC Devices using an Omni Console
To configure HLC devices from an Omni console, use the Status menu. To enter the Status menu, from the
STATUS
1=CTRL 2=ZONE 3=SUN ↓
Press 1 (CTRL) to view the current status of each unit and to configure the HLC device that is assigned for each unit. The console will display:
Porch Light |
|
STATUS OFF | ↓ |
You may enter a unit number to display the selected unit, or simply press the down arrow key to scroll through the list of named units.
When the desired unit is displayed, put the selected HLC device into Setup Mode (See - Setup Mode for HLC Devices), and then press the ' # ' key twice (i.e. # #). The display will provide you with
CONFIGURE Porch Light
COMPLETED
33
