Home Automation SECURITY SYSTEM owner manual Step, Operation, Controlling CentraLite Units

Each lighting scene can also be set or easily changed using the pushbuttons on the HAI UPB™ 6-Button Room Controller, as follows:

Step Operation

1Press the desired pushbutton on the HAI UPB™ 6-Button Room Controller to activate the current scene (preset lighting level) in each of the HLC devices.

2Use the local Decora-style rocker switch on each UPB™ Wall Switch Dimmer(s) to set the desired lighting level(s) or issue commands from the OmniLT controller.

3Press the pushbutton on the HAI UPB™ 6-Button Room Controller five (5) times quickly.

4Each UPB™ Wall Switch Dimmer will flash its lighting load one time to indicate that the new level has been configured.

Controlling Individual Lighting Loads in an HLC Room or UPB Units

To control individual lighting loads in a room, use the down arrow key to scroll through the list of units. When the unit is displayed, press the ' # ' key. For HLC/UPB lighting loads, the console will display:

LR Sconce

0=OFF 1=ON 2=DIM 3=BRT ↓

LR Sconce

4=LVL 6=LED 9=TIM #=STA↑

¾Press 0 (OFF) to turn the selected lighting load off .

¾Press 1 (ON) to turn the selected lighting load on.

¾Press 2 (DIM) to dim the selected unit (1-9 steps, each step is 10% from its current level).

¾Press 3 (BRT) to brighten the selected unit (1-9 steps, each step is 10% from its current level).

¾Press 4 (LVL) to set the desired lighting level of the selected unit (0%-100%).

¾Press 6 (LED) to turn on or off the LED behind the specified button on a general purpose 8-Button or 6-Button Keypad.

•Specify 1-8 to control the LED behind buttons 1-8 respectively, and then select 0 (OFF) or 1 (ON).

¾Press 9 (TIM) to time the selected unit (On, Off, Dim, Brighten).

•Timed commands may be from 1-99 seconds, 1-99 minutes or 1-18 hours.

¾Press # (STA) to see the exact status of a UPB device. When the ' # ' key is pressed, OmniLT sends a “Status Request” message to the selected device for its current state. The exact state is then displayed.

LR Sconce

STATUS 67%

Note: When a UPB signal is received over the powerline, OmniLT will automatically update the status of the device.

Controlling CentraLite Units

Entry Lights

0=OFF 1=ON 2=DIM 3=BRT ↓

Entry Lights

4=LVL 5=RMP 9=TIM #=STA↑

¾Press 0 (OFF) to turn the selected unit off.

¾Press 1 (ON) to turn the selected unit on.

¾2 (DIM) does not affect CentraLite units.

¾3 (BRT) does not affect CentraLite units.

¾Press 4 (LVL) to set the desired lighting level of the selected unit (0%-100%).

19