MAINTENANCE 8, ADJUSTMENTS -
9. Release the neutral locks and cycle the direction control
levers forward and backward several times. Engage the
neutral locks and be sure the wheels come to a complete
stop. Readjust the linkage if necessary.
10. With the neutral locks engaged, adjust both reverse springs
to a length of 2.3 - 2.4 inches (58 - 62 mm).
Speed Control Linkage Adjustment
Perform this adjustment if the mower creeps when the speed
control levers are in neutral and the neutral locks are
released.
1. Raise and support the rear of the mower so that the rear
wheels are clear of the ground.
2. Pull the forward speed control levers into neutral and engage
the neutral locks on the direction control levers.
3. Loosen the locknuts on the forward speed linkage.
4. Adjust the length of the rod until the roller just contacts the
pump control arm with no slack in the linkage. Adjust the
other side the same way.
5. Start the engine, move the throttle lever to FAST, and
release the neutral locks.
6. Adjust each forward speed linkage rod:
l
Turn the adjusting nut to lengthen the rod until forward
rotation just starts.
l
Turn the adjusting nut, counting the number of turns, to
shorten the rod until rear rotation just starts.
l
Turn the adjusting nut to lengthen the rod one-half the
number of turns you counted.
7. Tighten the locknut. Adjust the linkage on the other side in
the same manner.
8. Adjust both pump arm springs to a length of 4.5 - 4.9 inches
(115 - 125mm).
9. Cycle the forward speed control levers from neutral to full
forward a number of times. Readjust the linkage to stop any
wheel rotation in neutral.
54