~~~ | Honda Power Equipment MM60 guide

~

~~~

~~

INSTALLING MOWER

4. Put the transmission range selector in "1.I' For A-4 models, engage 4-wheel drive. Press the clutch, put the main transmission selector in "l", and slowly drive over the mower, controlling your speed with the clutch.andbrake.

5. Shut engine off after driving front wheels over mower and remove key from ignition.

Attaching Rear Mower Links to Tractor Frame

1. Adjust the gauge wheels to their middle cutting position (2 in).

2. Roll the deck forward or backward, right or left to position the rear links under the quick-release pins.

3. Attach the left rear mower link first. Pull back on quick release pin, then liftmower link by hand to the frame brackets. If holes in rear link do not line up with frame bracket, adjust the position of the mower until they do. Keeping the holes lined up, pull the quick release pin towards you and turn it to fit it into the holes. Releaseto lock. Make sure that the pin reaches through the

Rear Mower Links Attach to Mo-werholes inside the frame bracket. Shake the rear mower link to check for free movement.

4. Attach the right rear mower link in the same. manner.

22

Image 24

Honda Power Equipment MM60 manual ~~~

Contents

Page Page Introduction To the Owner Introduction General INFORMATlON Contents Safety Information Operate equipment Safety Information Preparation Maintenance Safety Block mower securely for storage Safety Information Replace immediately if damaged SET-UP and Assembly SET-UP and Assembly SET-UP and Assembly Point out safety features, shielding and optionsPre-Delivery Check List Dealer Responsibility SET-UPAND Assembly Finish by tightening two 26 mm flange locknuts Lift Unk SET-UP and Assembly ‘y85 mm With Three Point Subassembling Front Link Brackets Assemble both right and left bracketsMounting Front Link Bracket to.Tractor Installing Mower Installing Deck Hooks Level the mower to assure proper cut. Mower Installing Mower Installing Front Anti-ScalpingRoller Install both plugs Remove level plug Add oil until it seeps out level plug hole Side. Insert linchpin to lock Attaching Front Mower Links To Mower ~~~ Attaching Front Mower Links to Front Bracket Lift Arms Fasten to Mower Deck Detaching Mower from Tractor Joint Detaches From Mid-PTO Switch off engine after moving tractor off mower. Set brakes Tor to 4-wheel drive position Operation Operation PRE-OPERATION Check List Tours A small area Installing Mower Operating Your Mower with Other Equipment ‘ by mower deck hook Install attachment as needed Maintenance Owner Service Caster Pivot Hrs Caster Wheel Blade Spindles Driveshaft U-joints HrsDriveshaft Slip Joint Hrs Spring Take-up Pivot Arm 30W Oil Oil Level Plug Blade Inspection Blade Installation Blade Servicing Maintenance Belt Assembly Maintenance Spindle assembly @ Sleeve Bearing cone Housing and cups Cup Shaft Spindle Assembly Remove bearing cone from shaft Proper adjustment is attained T1I Universal Joint Assembly Yoke Journal cross Seal Snap ring Cup and bearings L11 Andhammer Gearbox Maintenance Remove gearbox from stand Gear Box Split taper bushing Drive pulley Gearbox stand Key Storage Storage Troubleshooting ProblemSolution Troubleshooting Specifications Warranty Service Owner Satisfaction