TROUBLESHOOTING
PROBLEM
1.Tractor speed too fast
2.Grass accumulation inside deck
3.Dull Blade
4.Tires improperty inflated
5.Mower not level
6.Wrong mower deck height
7.Engine speed too low
1.'Blade driie belt worn or broken
2.Mid PTO not selected
3.Faulty PTO clutch or worn disk
1.Wrong blade
2.Deck too low
3.Engine overloaded
4.Lawn wet or watered
5.Lawn too tall
6.Engine speed too low
~~_ _ _ _ ~ ~ ~ ~
SOLUTION
I . shift to lower~~~gear~~~.
2.Clean deck underside.
3.Have the blade sharpened or replace it.
4.Check the tire inflation.
5.Check the blade height.
6.Change to proper height.
7.Run at full throttle.
1.Replacewith new belt.
2.Check PTO Selector Lever position
3.See your authorized HONDA
1.Use genuine HONDA blade or equivalent.
2.Raise deck and adjust deck height properly..
3.Operate at full throttle. Use lower speed range. Set mower deck higher than ,desiredheight for
first pass, then cut to desired height on second pass.
'4. Allow to dry before cutting.
5.Set mower deck higher than desired height for first pass, then cut to desired height on second pass.
6.Run at f u l l throttle. (Do not exceed 2400 rpms on
1. Cutting height too low | 1. Increaseto proper height. | ||
2. | Tractor speed too high | ,2. Lower to proper speed. | |
3. Uneven surface | 3. | Change cutting pattern. | |
4. | Rough and uneven surface | 4. Adjust with height adjuster. | |
1. Unbalanced blades | 1. Adjust balance. | ||
2. | Driveblade belt damaged | 2. | Replace. |
3. | Pulley(s) damaged or out of alignment | 3. See your authorized HONDA | |
|
|
| tractor dealer. |
4. | Lack of gearbox lubricant | 4. | Lubricatewith SAE 90 weight gear lubricant |
1. | Engine speed too low | 1. | Run at full throttle. (Do not exceed 2400 rpms |
|
|
| on |
2. | Tractor speed too fast | 2. | Lower to proper speed range. |
3. | Pebbles or other foreign matter are stuck | 3. | Remove. |
| in mower deck |
|
|
54
