Honda Power Equipment MM60 manual Lift Unk

SET-UP AND ASSEMBLY

Lift Unk Lower Link Shaft

\

Y- bracket

Lower Link

Attaching Lift Link to Lift Plate Assembly (For Tractors Without Rear Three Point Hitch)

1.Slide middle hole in lift link onto greased left hand lower link shaft which comes installed on the tractor. Install lift link so that it is vertical and the end with two holes is down. Lift link should face reaward as illustrated. Be sure to apply grease to shaft. Secure with linchpin.

2.Use a block of wood to raise left arm of lift plate assembly about 150 mm (6 in) to make attach- ing the Y-bracket and the bottom hole of the lift link easier. Line up hole in Y-bracket with lower hole in lift link moving arm and lift link until they align. Insert greased 22 mm x 76 mm clevis pin and secure with cotter pin, passing pin from top to bottom. Head on clevis pin faces in.

Attaching Lift Link to Lift Plate Assembly (For Tractors With Rear Three Point Hitch)

1.Remove left hand three point hitch lower link from lower link shaft.

2.Mount lift link and-lower link back on lower link shaft by lining up middle hole in lift link and hole in lower link. Pass greased lower link shaft through both as illustrated. Secure with linchpin, passing pin from top to bottom.

3.Support lift plate assembly arms on block of wood as described above. Move lift link and Y- bracket on lower lift plate assembly until hole in Y-bracket and bottom hole in lift link line up. Insert greased 22 mm x 57 mm clevis pin with head facing in and secure with cotter pin, passing pin from top to bottom.

12