between scan codes. Set the length (in milliseconds) for a delay by scanning the bar code below, then setting the delay (from 1-30) by scanning digits from the Programming Chart, then scanning Save. Default = 0 (800 µs).

Inter-Scan Code Delay<F0> Break Character

When your keyboard detects that any key is being pressed, released, or held down, the keyboard sends a packet of information known as a “scan code” to your computer. There are two different types of scan codes:

“make codes” and “break codes.” A make code is sent when a key is pressed or held down. A break code is sent when a key is released. The following selections allow you to suppress or transmit the character sequence of the break code. Default = Transmit.

Suppress* TransmitKeyboard Wedge Defaults

If you want the custom keyboard wedge default settings restored to your scanner, scan the Keyboard Wedge Defaults bar code below. This resets the scanner to the custom default settings (see Setting Custom Defaults on page 1-5). If there are no custom defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified through the custom defaults will be defaulted to the factory default settings.

Keyboard Wedge Defaults

2 - 24