Object Detection Distance

When the scanner is in the stand and you are using Object Detection Mode, you can set the distance range for detecting objects. Short sets the scanner to detect objects approximately 5 inches (12.7cm) away from the nose. Long sets it to detect objects approximately 10 inches (25.4cm) away. Default = Short In-Stand, Long Out-of-Stand.

*Short In-StandLong

In-Stand

Short

Out-of-Stand

* Long

Out-of-Stand

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received, the scanner continues scanning until either the Character Activation Laser Timeout (page 3-14),the deactivation character is received (see Deactivation Character on page 3-15),or a bar code is transmitted. Scan the On bar code below to use character acti- vation, then use Activation Character (following) to select the character you will send from the host to start scanning. Default = Off.

* Off

On

Activation Character

This sets the character used to trigger scanning when using Character Activation Mode. On the ASCII Conversion Chart (Code Page 1252) on page A-3,find the hex value that represents the character you want to use to trigger scanning. Scan the bar code below, then use the Programming Chart

3 - 13