Honeywell 1250G Character Activation Laser Timeout, End Character Activation After Good Read, Save, Save, End Character Activation After Good Read

to read the alphanumeric combination that represents that ASCII character. Scan Save to finish.

Activation Character

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the laser can be programmed either to remain on and scanning, or to turn off. When End Character Activation After Good Read is enabled, the laser turns off and stops scanning after a good read. If you scan Do Not End Character Activation After Good Read, the laser remains on after a good read. Default = End Character Activation After Good Read.

Do Not End Character Activation

After Good Read

* End Character Activation After

Good Read

Character Activation Laser Timeout

You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when using Character Activation Mode. Set the length (in milliseconds) for a timeout by scanning the bar code below, then setting the timeout (from 1-65535 milliseconds) by scanning digits from the Programming Chart, then scanning Save. Default = 5000 ms.

Character Activation Laser

Timeout

3 - 14