Honeywell 1250G XON/XOFF, RS232 Timeout, Save, No Timeout, XON/XOFF On, XON/XOFF Off, * RTS/CTS Off, RS232 Timeout, Flow Control, No Timeout, Two-DirectionFlow Control

and CTS is not asserted, the device transmit buffer is cleared and scanning may resume.

Default = RTS/CTS Off.

Flow Control, No TimeoutCharacter-Based Flow Control,No TimeoutTwo-Direction Flow ControlFlow Control with TimeoutCharacter-Based Flow Control with Timeout* RTS/CTS OffRS232 Timeout

When using Flow Control with Timeout, you must program the length of the delay you want to wait for CTS from the host. Set the length (in millisec- onds) for a timeout by scanning the bar code below, then setting the timeout (from 1-5100 milliseconds) by scanning digits from the Programming Chart, then scanning Save. Default = 1000 ms (1 second).

RS232 TimeoutXON/XOFF

Standard ASCII control characters can be used to tell the scanner to start sending data (XON/XOFF On) or to stop sending data (XON/XOFF Off). When the host sends the XOFF character (DC3, hex 13) to the scanner,

2 - 28