End Object Detection After Good Read

After a bar code is successfully detected and read from the scanner, the laser can be programmed either to remain on and scanning, or to turn off. When End Object Detection After Good Read is enabled, the laser turns off and stops scanning after a good read. If you scan Do Not End Object Detection After Good Read, the laser remains on after a good read. Default = End Object Detection After Good Read.

Do Not End Object Detection

After Good Read In-Stand

* End Object Detection After

Good Read In-Stand

Do Not End Object Detection

After Good Read Out-of-Stand

* End Object Detection After

Good Read Out-of-Stand

Object Detection Laser Timeout

You can set a timeout for the length of time the laser remains on and attempting to decode bar codes after an object is detected. Set the length (in milliseconds) for a timeout by scanning the bar code below, then setting the timeout (from 1-65535 milliseconds) by scanning digits from the Programming Chart, then scanning Save. Default = 5000 ms.

Object Detection Laser

Timeout In-Stand

Object Detection Laser

Timeout Out-of-Stand

3 - 12