Base Power CommunicationIndicator Off

Reset Scanner

Scanning this bar code reboots the scanner and causes it to relink with the base or Access Point.

Reset Scanner

Scanning While in Base Cradle

If you want to be able to scan bar codes while the scanner is in the base cradle, scan the Scanning in Cradle On bar code below. If you want to only allow scanning when the scanner is out of the base cradle, scan Scanning in Cradle Off. If you want

the scanner to shut down when in the base cradle, scan Shut Down Scanner in Cradle. Default = Scanning in Cradle On.

Scanning in Cradle Off

* Scanning in Cradle OnShut Down Scanner in Cradle

Base Charging Modes

When the base has both an external power supply (plugged into the auxiliary power port) and a host interface cable, it will draw its power from the external power supply. When the base does not have an external power supply, it draws its power from the interface cable. However, the scanner battery charges more slowly from a host interface cable than if auxiliary power were available. Using the following selections, you can specify whether the scanner battery is charged from power supplied via the host interface cable.

When Base Charge Off is selected, the scanner battery does not charge when the scanner is in the base cradle.

When External or Interface Cable Power is selected, the scanner battery charges from the base’s external power supply, if there is one. If there is no external power supply to the base, the scanner battery charges from the interface cable.

When External Power Only is selected, the scanner battery only charges from the base’s external power supply. If there is no external power supply, the scanner battery does not charge.

Note: If you are using a cordless charge base in Presentation Mode, External Power Only is the only setting available.

3 - 6