When in Batch Mode, you may wish to transmit the number of multiple bar codes scanned, rather than a single bar code multiple times. For example, if you scan three bar codes called XYZ with Batch Mode Quantity Off, when you transmit your data it will appear as XYZ three times. Using Batch Mode Quantity On and the Quantity Codes (page
Note: If you wish to format your output, for example, place a CR or tab between the bar code data and the quantity, refer to Data Formatting beginning on page
Default = Batch Mode Quantity Off.
* Batch Mode Quantity Off
Batch Mode Quantity On
Entering QuantitiesQuantity Codes (page
For example, if the Quantity 5 bar code is scanned after the quantity has been set to 1234, then the 1 is dropped, the quantity will be 2345.
Example: Add a quantity of 5 for the last item scanned.
1.Scan the item's bar code.
2.Scan the quantity 5 bar code.
Example: Add a quantity of 1,500 for the last item scanned.
1.Scan the item's bar code.
2.Scan the quantity 1 bar code.
3.Scan the quantity 5 bar code.
4.Scan the quantity 0 bar code.
5.Scan the quantity 0 bar code.
Example: Change a quantity of 103 to 10.
To correct an incorrect quantity, scan the quantity 0 bar code to replace the incorrect digits, then scan the correct quantity bar codes.
1.Scan the quantity 0 bar code to change the quantity to 1030.
2.Scan the quantity 0 bar code to change the quantity to 0300.
3.Scan the quantity 1 bar code to change the quantity to 3001.
4.Scan the quantity 0 bar code to change the quantity to 0010.
Default = 1.
Quantity Codes0
3 - 15