If there are no trigger pulls during the timer interval, the scanner goes into power down mode. Whenever the trigger is enabled, the timer is reset. If the scanner is placed in the charge base cradle and the battery is in the process of being charged, the

scanner will not go into power down mode. Default = 3600 seconds.

0 seconds200 seconds400 seconds900 seconds* 3600 seconds7200 seconds

Note: When the scanner is in power down mode, pull the trigger to power the unit back up. There will be a set of power up beeps and a delay of up to a few seconds for the radio to join. The scanner will then be ready to use.

Flexible Power Management

If you are experiencing network performance issues, and suspect the scanner is interfering with other devices, you can turn down the power output of the scanner. This reduces the range between the scanner and a base or an Access Point as shown in the following illustration:

802.11

1902

LAN

Scanner

R

ed

u

c

e

 

 

r

 

e

w

 

dPo

 

 

Fu

ll

Power

3 - 12