2.Make sure the cables are secured in the wireways in the bottom of the cordless base and that the base sits flat on a horizontal surface.

3.The scanner beeps.

4.Verify the scanner or cordless base operation by scanning a bar code from the Sample Symbols in the back of this manual.

The unit defaults to a USB PC Keyboard. Refer to page 2-4for other USB terminal settings.

For additional USB programming and technical information, refer to “USB Application Note,” available at www.honeywellaidc.com.

Connecting with Keyboard Wedge

A scanner or cordless base can be connected between the keyboard and PC as a “keyboard wedge,” plugged into the serial port, or connected to a portable data terminal in wand emulation or non decoded output mode.

The following is an example of a keyboard wedge connection:

1.Turn off power and disconnect the keyboard cable from the back of the terminal/computer.

2.Connect the appropriate interface cable to the device and to the terminal/computer.

Corded Scanner Keyboard Wedge Connection:

1 - 3