Event

Auto Reconnect On

Auto Reconnect Off

 

 

 

Scanner power

Trigger must be pulled, Access Point linking bar

down due to Power

code must be scanned, or the scanner must be

Time-Out Timer

placed in the base unit to relink.

setting (see page 4-

(Note: scanner relinks on power up, but powers

7)

on due to one of the above actions.)

Scanner reset due

Relink occurs automatically.

to firmware

 

 

upgrade

 

 

Scanner reset due

Relink occurs automatically.

to battery change

 

 

Scanner placed in

Relink to new base occurs automatically.

different base unit

 

 

 

 

 

Maximum Link Attempts

The Maximum Link Attempts setting controls the number of times the scanner tries to form a connection with a base or an Access Point. During the connection setup process, the scanner transmits in order to search for and connect to a base or an Access Point. In order to prevent continuous transmissions that could interfere with other users of the ISM band, the number of attempts to connect is limited by this setting. After the maximum number of attempts is reached, the scanner will not attempt to reconnect to a base or an Access Point. Pressing the trigger, scanning an Access Point linking bar code, or placing the scanner in the cradle resets the attempt count and the scanner will again try to link.

Scan the Maximum Link Attempts bar code, then scan the number of attempts for the setting (from 0-100) from the inside back cover. Scan Save to save the setting. Default = 0.

Maximum Link Attempts

Note: When Auto Reconnect Mode is On, setting Maximum Link Attempts to zero will cause the scanner to try to link until the Power Time-Out Timer setting (see page 4-7)expires. When Auto Reconnect Mode is Off, setting Maximum Link Attempts to zero will cause the scanner to only attempt linking one time after a trigger pull.

3 - 29