code below and then set the time-out duration (from 0-3000 seconds) by scanning digits on the Programming Chart inside the back cover, then scanning Save. Default = 0 sec (no alarm).

Base Alarm Duration

Note: The Access Point does not have a base alarm.

Scanner Alarm Duration

Note: If you are out of range when you scan a bar code, you will receive an error tone even if you do not have the alarm set. You receive the error tone since the data could not be communicated to the base or Access Point or the host.

Alarm Sound Type

You may change the alarm type for the scanner or base by scanning the appropriate bar code below and then scanning a digit (0-7) bar code and the Save bar code on the Programming Chart inside the back cover of this manual. Default = 0.

The sounds are as follows:

Setting

Sound

 

 

 

 

0

3 long beeps, medium pitch

 

 

1

3 long beeps, high pitch

 

 

2

4 short beeps, medium pitch

 

 

3

4 short beeps, high pitch

 

 

4

single chirps, medium pitch

 

 

5

2 chirps, then 1 chirp, medium pitch

 

 

6

single chirps, high pitch

 

 

7

2 chirps, then 1 chirp, high pitch

 

 

Base Alarm Type

Note: The Access Point does not have a base alarm.

Scanner Alarm Type

3 - 14